Running a fuel/oil ratio of 50:1 as was suggested by ils360. www.youtube.com – - – - – - – - – This is the work that I had done during this series : Replace both fuel lines Replace cracked fuel tank Replace missing air box Replace missing air filter Replace intake gasket Replace muffler gasket Replace cracked primer bulb Replace piston, piston ring, and connecting rod Repair cracked intake manifold Fix incorrectly assembled throttle control Fix cracked, and broken crankcase gasket Fix bent crankcase plate Clean, & re-gap spark plug to 0.025″ Remove, & clean muffler Remove, & clean spark arrestor screen Remove, clean, rebuild, and tune carburetor Remove, & clean all trimmer parts covered in two cycle oil – - – - – - – - – You can build-up your skills by owning these kinds of trimmers. Except in this case the last owner had beaten the shit out of it to where it wouldn’t run anymore. That’s pretty much what you get from Ebay!
UT20760 [Warm Start & Cutting Video]
Written by Tools on August 6th, 2010 in Power Equipment.
Tags: Cutting, START, UT20760, Video, Warm
i put a little 50:1 in my mini bike engine today lol. didnt have any straight gas and i wanted to ride lol
The oil leak has stopped. I ran the trimmer in the backyard cutting grass, and weeds for a matter of 5-7 minutes. White smoke from the muffler is still apparent, though not as bad as it was.
Compression is at 100psi. When the work was first started the reading was 85psi. Both cold readings.
sounds good at least the probs are fixed yay good video 5*****
It is running slightly rich, but at least that I know the problems from the past week are fixed.
Before this Thursday’s work I’ll lower the idle by 1/4 turn.
sounds good sound maby a little to rich but it sounds good =) nice video 5*****